Installing a Flow Sensor

The NLP organizes flow meters Hydraulically & can accommodate up to 20 flow sensors installed anywhere along the 2-Wire path. A flow sensor requires our universal sensor decoder (SD-110). The NLP has most common flow meters saved as preset SD-110 configurations for ease of set-up. 

Note: The following meter types are saved as preset configurations*:

• Tucor UFMV-A
• Tucor UFM
• Flomec QS-200
• CST FSI-T10/15/20
• Badger 220
• Badger 228BR25xx
• Badger 228CB20xx
• Bermad 900 DN40-DN100
• Bermad 900 DN150-DN200

Install SD-110

1. Navigate to   → 2-Wire → Decoder
2. Click
3. Select Discover new decoders (MK3 only)

Configure Universal Sensor Decoder

For Tucor Flow Meters

1. Navigate to → 2-Wire→IO
2. Find address of appropriate SD-110 by using search or filtering for "Input"
3. Use to edit & select Configure
4. Select appropriate Tucor flow meter model & click SAVE

Match Flow Sensor to a Pipe in Hydraulics

1. Navigate to   → Irrigation controller → Hydraulics
2. Click under Rule for the "Main" pipe you'll add the flow sensor to. For customers with >1 flow sensor, select the Rule of the appropriate Main or Sub-Main
3. This action will automatically create a flow rule. Mark the Active flag as Off for now. 
4. Click CREATE
5. Click FLOW SENSOR
6. Click
7. Open the IO dropdown and select the address of SD-110 installed with flow sensor.
8. Click CREATE

If you do not see your flow meter model, use the following link or contact us:

Installing a Standard Flow Sensor

*For controllers shipped after 10/1/24.